CPR 501 – Metal Paint – Epoxy HB – Rapid Cure

Typical Uses

£102.00£276.00 Excl VAT

In Stock
Clear

Description

Metal Paint – Epoxy HB – Rapid Cure

CPR 501 – Metal Paint – Epoxy HB – Rapid Cure is a two-pack Epoxy coating which provides protective and decorative properties to steel and other substrates. The material is supplied as a two-pack system, comprising pre-weighed amounts of BASE and CURING AGENT. After mixing together, an easily applied chemical and abrasion resistant finish is produced with fast curing characteristics.

Typical Properties

  • Rapid Cure
  • Solvent free, low odour
  • Very good chemical resistance
  • Excellent adhesion to concrete and steel
  • High build
  • Tough and durable
  • Easily applied
  • Hygienic and easily cleaned
  • Slip resistant options
  • Range of colours

Direction for Use

Surface Preparations Steel

  • Steel surfaces shall be shot blasted or grit blasted to a nominal Sa 2.5 Swedish standard.
  • All dust and grease shall be removed prior to coating application.
  • If a delay is likely to occur between blasting and application then it is recommended that a coat of CPR 808 – Metal Primer – Water Based is applied as holding primer to obviate flash rusting.

Mixing

  • Pour the contents of the CURING AGENT container into the BASE container and thoroughly mix, preferably by mechanical means until a uniform colour is achieved.

Application

  • Apply by brush, or roller at a nominal rate of 0.25 to 0.3kg/m².
  • After a minimum of 4 hours and before a maximum of 24 hours, apply a second coat at the same rate.
  • Should a non-slip finish be required, then broadcast an appropriate Quartz or other aggregate immediately after the first coat.
  • Allow to cure.
  • Brush off excess aggregate immediately prior to applying the second coat.

Curing

  • Allow to cure for a minimum of 4 hours @ 20°C prior to light foot traffic access and 10 hours @ 20° prior to vehicular trafficking.
  • 3 days cure @ 20°C is recommended prior to exposure to chemicals.
  • Lower temperatures will extend the curing time.

Equipment Cleaning

Limitations

  • Do not apply to wet or uncured concrete surfaces.
  • Do not apply at temperatures of 3°C or less.

Coverage

  • A 5kg pack is sufficient to treat 8.3-10.0 m2 of surface with the recommended two coat treatment, providing an overall d.f.t. of 400-450 microns.

Technical Data

  • Pot life @ 20C: 25 Minutes @ 10C: 50 Minutes
  • Colours: Grey, Red (BS4800 or RAL colours available on request)
  • Coverage: 0.25-0.30kg/m²/coat
  • Tack free time @ 20°C: 2 hours
  • Hard dry time @ 20°C: 4 hours
  • Full chemical resistance @ 20°C: 3 days
  • Adhesion strength to concrete: 3.9 MPa (concrete failure)
  • Adhesion strength to mild steel: >12 MPa

Chemical resistance

  • Excellent resistance to dilute acids, dilute alkalis, oil, petrol, diesel, vegetable oils.
  • Please consult our Technical Department for specific advice.
  • All products shall be applied strictly in accordance with the manufacturer’s instructions.

Shelf Life

  • Store in dry conditions, out of direct sunlight, at temperatures between 10°C and 25°C.
  • CPR 501 – Metal Paint – Epoxy HB – Rapid Cure has a minimum shelf life of 12 months when stored in original, unopened containers in accordance with manufacturer’s instructions.

Packaging

  • CPR 501 – Metal Paint – Epoxy HB – Rapid Cure is supplied in 5kg and 15kg packs

Safety Precautions

  • Avoid contact of the material with skin and eyes.
  • Wear gloves and goggles.
  • Wash off splashes immediately with soap and water.
  • Any eye contamination must be rapidly irrigated with copious amounts of clean water, and immediate medical attention sought.
  • Please refer to Material Safety Data Sheet for additional information.

Legal Notice

Whilst all reasonable care is taken in compiling technical data on the Company’s products, all recommendations or suggestions regarding the use of such products are made without guarantee, since the conditions of use are beyond the control of the Company.

It is the customer’s responsibility to satisfy himself that each product is fit for the purpose for which he intends to use it, that the actual conditions of use are suitable and that in the light of our continual research and development program the information relating to each product has not been superseded.

 

Additional information

Weight N/A
size

15kg, 5kg

CPRL Colours

Black (RAL 9005), Carmine Red (RAL 3002), Iron Grey ( RAL 7011), Leaf Green ( RAL 6002), Light Grey (RAL 7035), Oxide Red (Ral 3009), Signal White (RAL 9003), Silver Grey (Ral 7001), Sky Blue (RAL 5015)

Brand

CPRL

Reviews

There are no reviews yet.

Be the first to review “CPR 501 – Metal Paint – Epoxy HB – Rapid Cure”

Your email address will not be published.