Fosroc – Nitoseal Primer MS2
Nitoseal Primer MS2 is a two-component solvent-based epoxy resin primer designed for priming before application of the sealant. The 750ml packs are easy to apply and have exceptionally strong adhesion properties.
Empty the entire contents of the hardener tin into the base tin, replace the base tin lid. Mix thoroughly, by shaking for 2 minutes.
Prime the joint face using a clean dry brush. Avoid over-application of primer causing puddles in the bottom of the joint.
Sealants should be applied between 30 minutes and 4 hours after priming. If the joint is not sealed overnight the primer film should be removed by grit blasting or grinding and the joint reprimed.
The mixed Primer MS2 must be applied within one working day. Do not use part packs.
Clean equipment immediately after use with Fosroc Solvent.
Primer MS2: 500 ml can
Fosroc Solvent 102: 4 litre can
Storage & Shelf-life
12 months if stored in the original unopened packs in a cool dry place.
Do not store in direct sunlight.
Health and Safety
Nitoseal Primer MS2 may be harmful if swallowed or inhaled and may cause skin and eye irritation.
Product contains a very small amount of isocyanates and low flash point solvent. Should accidental skin contact occur, remove contaminated clothing and wash with warm soapy water. Do not scrub.
If inhaled remove the person to fresh air. Get medical advice if breathing becomes difficult.
In case of contact with eyes, rinse immediately with plenty of clean water for at least 15 minutes and seek medical advice.
If swallowed, give a glass of water to dilute and seek medical attention immediately – do not induce vomiting.
For further information, refer to the appropriate Product Material Safety Data Sheet.
Nitoseal Primer MS2 and Solvent 102 is highly flammable liquid. Keep away from sources of ignition. No smoking.
Containers should be tightly sealed when not in use. In the event of a fire, extinguish with CO2 or foam. Do not use a water jet.
Click below for full product data sheet: